Step 1
FlexPro comes in various panel configurations a well as roll and stick package options. Apply the FlexPro Ridge Vent to metal roof by removing the backing paper.
Step 2
Align the FlexPro Ridge Vent 1/2”-1” up-slope from the edge of the ridge cap. Place onto metal roof with adhesive side down. Note that the adhesive is strong and once put in place, it will be hard to move. Be sure the FlexPro Ridge Vent is in place the first time.
Step 3
When attaching consecutive FlexPro Vents, butt fit the pieces together. Marco’s Weather-Tite Metal Roof Sealant can be used to seal the butt joint. Place ridge cap over FlexPro. Secure in place with Marco QuickGrip™/QuickDrill™ fasteners; fasten through the metal roof ridge locations using a min. 3300 rpm screw gun, avoiding penetrating the FlexPro material.
Step 1
FlexPro comes in various panel configurations a well as roll and stick package options. Apply the FlexPro Ridge Vent to metal roof by removing the backing paper.
Step 2
Align the FlexPro Ridge Vent 1/2”-1” up-slope from the edge of the ridge cap. Place onto metal roof with adhesive side down. Note that the adhesive is strong and once put in place, it will be hard to move. Be sure the FlexPro Ridge Vent is in place the first time.
Step 3
When attaching consecutive FlexPro Vents, butt fit the pieces together. Marco’s Weather-Tite Metal Roof Sealant can be used to seal the butt joint. Place ridge cap over FlexPro. Secure in place with Marco QuickGrip™/QuickDrill™ fasteners; fasten through the metal roof ridge locations using a min. 3300 rpm screw gun, avoiding penetrating the FlexPro material.